Skip to content

Facility 2 - Channel Control

Facility 2-channel control

Would you like to switch two different circuits independently of each other with the C303 receiver and are you wondering how to connect the respective channels? Then we have the answer for you here.

Before you can start, please make sure that your receiver is correctly connected to the power grid and that all the desired lights are connected to both channels. Otherwise pairing is not possible. If everything is connected correctly, we can get started.

Channel One
Step 1: Your receiver has a control button on the top. Please hold this down for 3 seconds. The status light on the receiver will now start flashing and you can release the control button. The communication mode is now active.

Step 2: Now briefly press your radio switch or the desired button. As soon as the status light on the receiver goes out, the pairing is successfully completed.

Channel Two
Step 1: Now switch to the second channel by pressing the control button on the receiver twice in quick succession. The signal light now changes from red to blue. The second channel is successfully selected and you can initiate the pairing process as with channel 1.

Now repeat this process with all switches or buttons that should be trained to the respective channel of your receiver.

Note: Each 2-channel receiver stores up to 10 switches or button information per channel.

Important: Suitable for all switches and the C303 receiver.

Back to top